Is there a proper way to iron clothes?
Answers:
A proper, full sized, non-wobbly ironing board is very important. Otherwise you iron can fall on the floor, also your spray starch.
A good steam iron is also important. Be careful to lower the temperature for synthetics like nylon. These can melt all over a hot iron and ruin it so it will not glide until properly cleaned.
Proper lighting and a clean, washable rug under the front and middle of the board is also important, so that long trousers, long items are not wiping the floor while you work on them.
Use distilled water or water from a Brita filter in your iron to extend its useful life by preventing deposits; also prevents staining of white items, fancy dresses from impure tap water.
I learned the hard way about this as a Navy Corpsman. One time I was ironing a sparkling white uniform and in a hurry. The spray starch fell off the wobbly board and the cap busted off when it hit the floor. It started spinning around in circles, spraying startch everywhere.
I grabbed the sprinning spray starch and pointed it into the rug I used for keeping whites off the floor while ironing and held it there until it expiated itself. Then I smelled something burning...I had left the very hot iron on my brand new white uniform, now having a very brown, iron-shaped scorch. Muttered expletives...I did not have another clean set of unironed whites and the clock was ticking. I had to touch up yesterday's uniform and hurry to work after cleaning up all the mess.
You have to get the temperature right. The spray setting for water comes in handy. I recommend always using the steam. Linens and cottons like hot, but this is not necessary for wrinkle-free mens shirts, turn it down a bit.
For wool suits and thick items use lots of steam, keep the clean water refill bottle handy.
That's my experience, important to follow, especially if you have a lot of ironing.
Other answers:
first make sure your iron is hot, no sense ironing with just lukewarm irons, doesnt do the job well. If your iron has fabric type settings then use this , and if steam is an option on iron, this works well for shirts and crease in pants, when ironing collars and cuffs this is heavier material , put steam on areas and press hard with iron for crisp looking collars.
first make sure your iron is hot, no sense ironing with just lukewarm irons, doesnt do the job well. If your iron has fabric type settings then use this , and if steam is an option on iron, this works well for shirts and crease in pants, when ironing collars and cuffs this is heavier material , put steam on areas and press hard with iron for crisp looking collars.
I hate ironing and if I can have someone else iron for me, i welcome it. I think steaming is much easier.. just hang it and swipe away.
yes use a steam iron and put the heat according to the material of the garment if the iron does not have enough steam you can spray the garement lightly with a fine spray for water it helps to remove creases completely
Since an explanation might be too long, I'll just say this: Conan O'Brien had Martha Stewart as a guest on one of his shows (back in the late 90's or early 00's). She demostrated the proper way to iron a dress shirt. I've ironed my shirts that way ever since, and LOVE the way they come out. If you needed a demo, I'm wondering if you could order the episode from the studio? Most shows like that have an archive and will send you the video for a nominal fee.
Anyway, I don't remember if she covered pants, as most nicer pants are dryclean only anyway... at least I guess.
Good luck!
Try a steamer.
Never put your iron too hot! You'll melt your husband's dress clothes and they sure burn easily. Make sure you understand the lever on your iron. Cotton and Linen usually requires intense heat, Polyester very low heat. The trick is to have a spray bottle water next to you. Everytime you place a section to iron, spray a thin vapour of water on the segment and begin to iron slowly. Watch out for the steam and yes, of course a steam iron works better!