Washer is agitating usually, but once surrounded by spin cycle, it almost not spins and make a clacking/scratching clap?
Answers: sounds approaching a belt tensioner is broken, or your belt is worn.
My guess is the gear box that connects to the agitator and the motor has broken or worn out.......Good Luck
sounds resembling you have a loos belt or the bearing are wore out on your tub support check the belt first you mite nead a new belt.
The problem is a unusual belt.Or actually an dated belt.Get the model number to get the belt.Its uncomplicated to install,the front of the washer panel usually clips on.Its very barefaced where it go.Take the old one past its sell-by date,replace with unusual.It takes going on for 10 min. tops.Saves you a fortune on drying wet clothes.Also,even the legs on the washer.They are at the bottom.
Try looking up here:
http://www.acmehowto.com/howto/appliance...
http://www.repairclinic.com/0003.asp...
http://www.hometips.com/content/washers_...
http://www.hometips.com/home_probsolver/...
http://repair2000.com/wash.html...
http://home.howstuffworks.com/how-to-rep...
http://www.partselect.com/washing-machin...
I diagnosed the problem for my dryer at Repair Clinic and ordered the part later followed directions on how to fix it. Saved $400.00!
Check when it is in rinse cycle and take home sure your clothes are evenly distributed, If they are not you will get the bang around and your clothes will not spin like they should. If this is OK Then Try cleaning your tool, Take 8 Cups of White vinegar and do a wash next to out clothes. This will clean adjectives the residue in the electrical device that is not here from the washes you do. It will also verbs the drain pipe. See if that helps. This should be done every 6 months or at lowest once a year
More Questions and Answers...