Installing Kitchen cabinet to brick wall, help out??!?
Answers: same way as concrete/cinderblock
We used masonry nail or screws to attach a pouring deer head on our fireplace; although it is rock and not brick, I*m sure they would hold basically as well.
Why not ring a builder and ask what they recommend?
You will have to clip 2X4s to the brick wall by shooting nails surrounded by with a nouns gun near where on earth the top and the bottom of the cabinets will be. Then screw the cabinet into the 2x4s, you will need to close rotten the ends with some limited plywood stained to match the cabinet so the 2x4s don't show from the end.
You will inevitability a helper, for sure. Pre-drill the rail inside and under the cabinet, and hold it up to your horizontal line so your PA can mark through and show where on earth the holes will be on the brick wall. Then measure up to the nearest mortar string and either droop the cab a bit high or drill different holes.
Then use STRONG mortar anchors of your favorite type. An alternative way, if you hold the clearance, is to hang 1 x 4s vertically on 16 inch centers at the rear where the cabs will be, using mortar anchors near countersink screws. Then dangle the cabs with screw to the 1x4s in the usual mode. You can use a shoe molding or a small crown molding to hide the ends of the 1x4s at the bottom.
Then hold your homeowner out in the patio and kick his backside end HARD. That will craft it all seem to be worthwhile.
fur out the wall with wood, or you can liberate some time and use tapcons
More Questions and Answers...