How to install hardwood floors?
Answers: Unless you're experienced at it, I wouldn't recommend you do it yourself. But, if you insist ...
On a concrete floor, you have to bring in sure the floor is completely flat (not necessarily level, only flat). If it's not flat (cracking or buckling of the slab), you have to lay down a float of concrete repair compound and smooth it over, as though you be laying fresh concrete. You then use this stuff call duck glue to bonding agent the floorboards to the concrete.
If you're installing the floor on a wood subfloor, you have to remove adjectives other flooring until you get down to the subfloor (including any existing nail from an old wood floor). If in that are any areas that sag when you put your foot on them or that are rotting, you have to replace those areas next to 3/4-inch plywood. If you have any areas that squeak, you own to screw those down in place to stop the squeaking. Once you own the subfloor prepared, set down a layer of roughly speaking 30# tar serious newspaper for moisture resistance. Then you nail the floorboards into the subfloor.
Wood flooring have a tongue-and-groove on each board. The style the nails progress in is at the top of the groove and at a 45-degree angle into the board. That method the nails aren't detectable when the floor is installed and they don't interfere with the tongue-and-groove mate. Floor installers use a special pneumatic nail gun and nail for this where you place the board, push the gun up to the tongue, and rap the actuator to drive contained by the nail.
A couple other things you will manifestly need are a table saw and a compound miter saw. The table saw is used for adjectives the boards lengthwise, and the miter saw is for cutting the ends of the boards or for adjectives notches to fit around obstruction.
Absolutely precise measurements and cuts are essential to a good flooring installation. Again, if you don't hold the experience, I wouldn't recommend doing it yourself. Professional flooring installers get anywhere from $2 to $2.50 a square foot and they are unambiguously worth it.
Go to: http://www.hometips.com/articles/woodflo... there is a virtuous step by step tutorial.
Good luck!
More Questions and Answers...