Is at hand any accurate method of ensure the electric installation of my wooden house is safe and sound?

I've just bought a house explicitly made of wood, concrete floor but adjectives walls and ceiling is wood. The house had no electric installation, I'm going to flex it completely. I'm wondering if there is any technique or any special road of wiring the house beside regards to ensure the safety of it. As its wood, its remarkably easy to achieve burned with an electrical shock, hence the interrogate I ask.

Appreciate any help you can provide me.


Answers:    Wiring a complete house is a project for a professional electrician especially if you are concerned beside safety.
Standard residential electrical system practices will be all you requirement to know.

HOWEVER - if you have never done any electrics before, you'd better receive some help. At smallest some instructions. There are lots of ways to mess up an electrical installation.
You need to have a handle on the National Electrical Code at least ably enough to know how lots circuits, where to put GFCIs, how to size electric wiring for air conditioning/stove/dryer/water stove, etc.
If you're smart and otherwise handy with tools, it's possible to swot up the basics from a virtuous DIY book. And since you're the homeowner, in most places you can do the work yourself (since it's your décolletage...)
THE ONLY WAY TO DO THIS IS WITH AN INSULLATION TESTER COSTS AROUNTlb150+

SORRY CHEAPER TO GET SOMEONE IN, iF YOU DO NOT HAVE CORRECT TEST PAPERS COULD FIND INSURANCE INVALID
PETER
It'll also depend on any and all applicable codes/standards (to BO's answer above).

If you're routinely inclined you should be able to build the installation. Have a competent electrician friend that can show you the 'how tos' and lend help/provide periodic 'inspections'?

Once again I'm putting the pushcart before the horse today...
Before you start doing any physical work you might consider paying someone to consult (design) on this installation to ensure compliance w/applicable codes/standards/practices. This design may be required for power hookup by the electric co/permitting authorities... you didn't forget give or take a few permitting did you? *L*

Remember the code and standards folks hold the job of ensure our safety for most things electrical within nature...
go and get some help from a licensed electrician and you will be OK. Your give somebody the third degree indicates you do not know enough roughly this to go alone.
More Questions and Answers...
  • Using Quikrete adjectives purpose sand?
  • Can't obtain my not dangerous break open!?
  • Has any one used "SNOW ROOF" does it work?
  • Cheap foundation Ideas?
  • Can I paste a wood floor directly onto vinyl tiles?
  • Ebony stain how much to apply?
  • How tricky is it to replace a tub that fits from wall to wall snugly?