How come when i weld it doesnt produce a bead the rod only just get stuck?
Answers: A starting point for choosing the heat for a rod is to set the amps at one and the same number as the decimal size of the rod (1/8 inch rod would be 125 amps). Learn to drag the rod to start an arc in stead of beating to the metal, as you look at the melted metal astern the rod keep it surrounded by an egg shape. This is about adjectives I can tell you here except possibly go to the library and check out a book to serve you learn to weld or seize someone to teach you.
Holding the rod at the wrong angle, not adequate amps or too big a rod.
It should say on the bunch of rods what amperage range to use, if your welder does not progress that high after you need a smaller rod. Most welders also own some guide printed on them. I am really not a welder at least not arc, I can do line feed and oxy/acl but even lower than the expert guidence of someone who really knew how I could find what looked like a bead and the chipping sledge hammer would just blast it sour the base metal.
IT ISNT HOT ENOUGH
Use a 3 to 4 mm rod @ around 50/60 amps, make sure the rods are dry and check that you own a good land, if it still sticks put the current up a bit, also make sure the weld parts are shiny and clean. Use the mark method to get the arc started and later about 1 to 2 mm from the weld, it does run practice and you are not the only one that encounter this problem....a lot of learner think you can merely pick up a welder and go...it's not approaching that it takes a bit of practical experience... but it's resembling riding a bike, once you have mastered it. it's undemanding. So keep at it, its a right skill to have.
More Questions and Answers...