Wiring press.?
Answers: You don't say aloud where the black and red wires are.
If they are within the ceiling box you may have a three means of access switch going to the light. As for switches that don't do anything, draw from a tester (cheap at Ace Hdwe) to see if they have power going to them.
If the red and black wires are within the fan housing after you wired the adherent, the person is correct one is for the enthusiast and one is for the light.
To own a seperate switch for the light and follower you'll need to hold a seperate hot wire that is to say switched seperately for each.
This can be experienced in several different ways depending where on earth the power is.
If the power is in the wall and you hold a switch there, you'll entail to put in another switch, cable both switches to the hot lead, afterwards attach all the neutrals together including the two going to your restrained fixture. The two switched hot wires go to the pallid fixture, one for the fan and one for the pallid.
If the power is in the ceiling, you'll requirement to attach two hot wires to power source in the ceiling and appropriate them to the switches, one neutral comes past its sell-by date each indistinct connection contained by your fan/ light and bring connected together with the nonpartisan of the power source. The white wire that you run with the power to the switch, presently becomes your switched power cable to your light and admirer.
If you search the net, I'm sure you'll find diagrams so it will be easier for you to see what I explained.
The red and black hot wires that are always no also may be attached to the power source within the ceiling box.
If you decide to rewire as I suggested, I would support you to use 12/2 w/ ground wire. Just hook adjectives the ground (bare copper) wires together.
Sounds like you are going to fry it.
Get a voltmeter.
The black chain is your lights, and the red wire go to the fan if it's a ceiling follower your taking about? they both use equal ground. Locate the wall box with that electric wiring and maybe use a wispy and fan switch combination or separate switches if it's a double box. Just don't consent to the black or red wire touch the white telecommunication or the uninsulated wire. Those two switches are most potential where the wires are at and they may enjoy bypassed them which is why your wires are always hot. With the wall box adjectives the grounds should be wired in together, White wires next to white, bare copper to nude copper. The hot wire surrounded by the box needs to move about on each switch on the gold ingots screw, may have to rear a wire from one switch to the other. Place the red telecommunication on one of the switches, and the black wire to the other one, very soon you should be ready to install the supporter and a light contained by the future if that's what you want.
More Questions and Answers...