Whats the best way to remove bathroom tiles from the wall?

Got about 50 standard size tiles to remove from my bathroom. What would be the best way?

Answers:
hammer and bolster chisle. This type of chisle is about 100mm wide and wont damage the plaster if done carefully. You'll find that a lot of the tiles may come off with little effort.

Other answers:
sledgehammer
sledgehammer
Chisel and a hammer
Smashed mine off with hammer then got it skimmed.
I am a kitchen/ bathroom fitter. In short there is no easy way, you just have to hope that they have not been stuck on properly. If they are firmly stuck, then the only way to remove them is with a hammer and bolster. You will most likely damage the wall behind the tiles, so, you then have to repair that, i.e re plaster or new plasterboard walls.
There are a couple of cheating ways around this problem
1..if it is tiled floor to ceiling (as long as the tiles are stuck on well)then you can re plaster on top of tiles,
2....you can stick plaster board over the tiles and re plaster this.
But as I said, it is a horrible job, that can be quite dangerous (make sure you wear good quality gloves and eye protectors) and no real quick and easy answer.
My suggestion is to get a professional in to remove them and repair the damage caused.
hammer and a flat bar (a type of pry bar) ...careful ...damage plaster ...mud damaged ...if it becomes apairant that all u r doing is tearing up drywall cut along top of tiles w/a keyhole saw or utility knife. and think about your' boss,exwife ,oryour' boss w/ex and take out that anger .Oh mighty destroyer of bathrooms where only you and the throne reign.
Why not just tile over them if you can? Or put up tongue and groove?
  • why do women go off sex at 55?
  • French Polishing?
  • how do you stop the toilet and pipes to stop sweating?(my bathroom is underwater!!!)?
  • I have an Idea, but what is blueboard?
  • List the steps to replace a door slab.?
  • how do you sound proof a basement room (for playing the drums/big guitar amps ect In a very cheap way?
  • What's the best way to clean silver?
  • How do you use templates and a router for cutting wood?
  • Help calculating square footage please?