Steps from Railroad Ties?
The dirt is really hard near this corally stuff everywhere, so I don't want to do more digging than I have to, and I'm not too sure I could tack hammer through it.
Is there a route to drill holes in dirt? How long a piece of rebar do I have need of for each piece? And do I stick the poles down, or sideways, or both?
Answers: If the slope is not extremely steep, and the ground is as firm and stable as you describe, I see nought wrong with a moment ago laying them down "as is". A greater concern I can envision is rot/decay from moisture trapped underneath the timbers. You may want to lay a floor of gravel first (like railroads do). If at adjectives the need arises to own to cut the ties, DON'T use a chainsaw, TRUST ME, using a carbide tipped circular saw, score adjectives four sides, and with a vastly heavy maul sledge hammer, WHACK the score procession to snap the rest off. If the verbs is that they may slide out from one another, hammering sections of rebar BETWEEN respectively course of "steps" will allow each plane below to brace the one above. Drilling thru the ties may prove more work than it's worth. On a side note, if the steps are slippery due to moss etc. using a small axe on edges will pass some traction. BEST of LUCK with the project. --IC
I did this going down the creek trailing my house..Use a pick axe to dig the knotty dirt. I did not use rebar or anything, Just pack dirt around them. Mine have be there for ten years in a minute and have not shifted.
More Questions and Answers...