How do you install vinyl gutters?
Answers:
can be easy.after determining on what side the downspout will go,plane it downward towards that end.make a mark on one end of facia,then mark the other end of the facia board lower.about a 1/4 of an inch for every ten feet.snap a chalk line and install the gutter brackets.installing these are determined by the style you purchased.snap in your gutter,put on the end caps and install the elbows and downspout.brackets are used to secure the downspouts in place.a vinyl caulking is used for any seams and for the end caps.if the roofline is cut-up.you may want to leave it to a professional.good luck
Other answers:
There easy. Just measure your total footage and be sure to get all the elbows and tee fittings required to make bends and turns.
There easy. Just measure your total footage and be sure to get all the elbows and tee fittings required to make bends and turns.
go to home depot they stock them and they will have directions for do it yourselfers, yes they go up easy
If the gutters have pre drilled holes, use screws with rubber gromets. Make sure you do not use over or under size screws. Make sure you screw them into the ends of your rafters or trusses for strenth.