Making wish in good health what scope angle?
Answers: Both answers are equally valid. If rough framing, I just use a speed square. When it comes to finish woodwork, I use a miter saw. I'd have to check, but I don't entry 22.5 is marked on my speed squares (have a couple of sizes) but between 22 and 23. There's somewhat notch at the right angle and along the hypotenuse are little ticks from 1-89. Put the square on the board close to you are cutting a straight cut, after rotate until you get in the middle between 22 and 23. The leg of the square still on the board is 22.5.
speed squares are usually 45 and 90 degree a miter saw will pass you 22.5 degree
More Questions and Answers...