Leveling a floor?
Is not it that a Flat-floor, rather than a height floor is needed for tile/hardwood installation. A lot of times due to foundation shift, you could not make a even floor, or it would be out of sink with tha adjacent to rooms. If I am right:
Are there complication next to with Tile/Hardwood over a flat, but not a plane floor.
To flatten out a floor, I am told to use a 6' straight edge and find the gap. But, if I move this straight edge even a foot to the vanished, or right of where I started, the gap under the straight circumference would be moving elsewhere, the prior gaps would in a minute be flat with the staight margin.
I am all confused. Can you give support to please.
Answers: Find the highest spot surrounded by your floor and start there. Tie a string to a pin at that spot. Draw the string across the room and see what the gaps look similar to. You can put screws into the floor even near the line at a range of spots to give yourself an belief of the 'topograghy' of the floor. You can also use these screws as points to plane to with your 6 foot straight margin. Just move the leveler material until you see the tops of the screw.
A floor needs to be flat for tile, it is nice to be even too.
This is how we pour floors in mature loft buildings when the floors have to be height up to 300 ft. But a transit and laser is used as well.
I see no issue tiling a floor on a slant but yes its get to be relatively flat. The DIY floors such as laminate are a little forgiving beside the correct underlay but I don't know how much you are measure. vinyl tiles need it terribly flat. ceramic tiles can be made up next to extra adhesive if you are worthy.
You can buy self leveling compound that's a bit like totally watery cement when mixed if you necessitate to level a concrete floor.
You are correct within stating the a "flat-floor" is okay for tiling (or hardwood or whatever). What you have to be most concerned more or less is that each piece of any given floor covering lays flat and true on the substrate below.
For tile as an example: probably an 12 x 12 tile would rock on a hump or bump, but 2 6 x 6's, would go up and over the irregularity lay tight against the floor, that would be fine.
So the short answer is flat and true is more important than smooth.
if your Flores are unlevel and loose you will need to fix it from underneath the house. this is not unyielding to do but it is hard work crawling around below the house . but a great workout for the abbs
More Questions and Answers...