How do you install shower drain contained by existing concrete slab?
Answers: After you cut a hole in the slab where on earth will you connect to the existing drain line?
You might stipulation a contractor to do this job. Can you tunnel to where on earth the shower will be located? If it is near an out side wall it might not be that big of a problem.
Get the drain you are going to use and find out how big of a hole is required. Drill a hole within the slab in the desired location. Locate this nouns on the wall. Go outside and find where you necessitate to tunnel to reach this location. Dig a trench to the depth required by code contained by your location. connect the pipe you slide under the slab next to a ell on the end . stub the pipe to the required rank and connect it to existing drain leading to the man. Good Luck
Using any a concrete core drill to make the hole and if within is no drain lines in place---use an coarse saw to run the drain line from the hole to the existing sewage or brown sea line.
More Questions and Answers...