Bathtub Installation??
Do you have to install the hip bath or the FINISHED flooring first?
In other words, should we install the bathtub ontop of the plywood flooring we laid down? or do we inevitability to lay the floor tiles first and then install the hip bath ontop of the "finished" tiled floor?
Someone told me that you're supposed to rest the fresh bathtub ontop of the floor beam BEFORE laying down any floor tiles, but after I thought about adjectives the tile cutting that will be required to clash the shape of the bathtub once you ge up against the tub next to the tiles.
Wouldn't it be easier to lay down the tile first and then freshly place the tub ONTOP of the tile? Then there wouldn't be any tile cutting/shaping required right?
I don't know... I'm confused.
Any backing would be greatly appreciated! Thanks in advanced!
Answers: in good health youre friend is right.you have to lay and horizontal the new tub down first.later the new tile.but after set the tile down dry to see what is the best way and the least possible cuts.
You put the sub-floor (plywood) down over the beams, after install the bathtub, getting it stratum. I added insulation around the sides of the tub so that my bath dampen would keep reheat longer!
Once installed, you THEN do the tiling: otherwise you waste $, time, and tile putting surrounded by a floor under the tub that no one will see. You will HAVE to cut tiles while doing the floor, regardless... Make sure the plywood is height and the seams and screw holes are tape and filled surrounded by before you commence with the mastic. You can use a self-leveling compound to assistance with this, if critical.
To install tiles without adjectives them at the tub edge, consequently do this line of tiles FIRST when lay out your pattern. You should do the most distinct tile first, not the one that will be under the toilet... Tiles should be square to one another and beside the walls. There are a lot of polite DIY sites (or books at the library or book store) that explain the whole process.
Here is a apposite how-to for tiling around the tub (it took me a while, but it looked great in the close and saved a fortune): http://www.thisoldhouse.com/toh/how-to/i...
Yes, you _can_ do the tiling first, but as someone mentioned, it will affix some cost to the project. The upside is that you'll have the cleanest possible point at the tub, meaning that when you caulk it, you can return with away with a thoroughly small bead. It also provides for a little more protection should river seep underneath the edge of the tub.
If you're tempt to leave out some tiles lower than the tub, be sure that it's equally supported and level at adjectives contact points. Also, if it's a heavy tub, be wary jockeying it around when installing it, or you might scratch or crack some not long laid tiles - protect the floor with bits and pieces of plywood or thick cardboard, etc.
More Questions and Answers...