Can i Mow My Weeded Lawn Before i Apply a Fertilizer-Weed Conrol Mix?

I bought the Scotts Turf Builder Pro which is a Fertilizer-Weed Control Mix. I've been pulling weeds out all day with and am ready to apply the mix, however, because my lawn is so large part of my lawn still is covered in weeds. I am too lazy and would very much like to mow my lawn and then apply this Fertilizer-Weed Control Mix. Is this ok to do? Or should i apply the mix without cutting my lawn so that the weeds can receive full exposure to the mix?

Thanks

Answers:
Mow the lawn and spread the Turf Builder. If the lawn is a nice even level, the stuff will spread more evenly. If you let the weeds (and dandelions) stay tall, you risk them going to seed and re-seeding your lawn with weeds! If you can't spread the Scott's in the early am to catch the dew, you can water your lawn with sprinklers or a hose to give the granules something to "stick" to. If your lawn is huge, you can split it into 2 sections and water and spread one in the am and the other in the evening.

Other answers:
yes
yes
No, apply the mix first and let it take full effect before cutting. The weed-killing part of the mix will need to cling to the leaves, etc. of the weeds.

If you cut it down, it will have MUCH less to cling on to, only skinny little stems.
The fertilizer works at the root system.You can mow and then apply.
MOW THE LAWN--PUTS OWIES ON THE WEEDS AND THE WEED KILLER WILL LEACH IN BETTER AND TALL WEEDS NEED TO GO AS THEY ARE MAKING SEEDS AND MORE WEEDS.
use organic fertilizer or none at all. read the warnings on the bag of fertilizer, you are spreading poison that your pets and children will be exposed to and then it will leach into the groundwater and poison your lazy ***
weeds are killed at root, go ahead cut the grass
if you check the fine print you will most likely see atrazine as the weed killer. mowing wont make any difference to it. it works slowly so dont get disscuraged. regular mowing helps to keep the weeds from going to seed also.
  • I need advice on how to cut an existing formica counter top. I need to trim off approx. 1/2" for a new stove.
  • had a great roebuck builders trowel and lost it where can i find another please?
  • If a 2 by 10 supported on each end supports a stated load, will it do the same if supported in the middle?
  • Why do doors in England open away from the wall unlike elsewhere in Europe where they open towards the wall?
  • 'What can hold water even though it has holes?
  • how much does a 1/2'' sheet of osb plywood weigh?
  • how do you sharpen knives with a knife sharpner?
  • what shop in norwich sells a wide range of plastic extrusions?
  • Need warning something like handycapped ramp?