Why is my toilet cistern moving? Whats the fix?
Answers: You probably didn't do anything wrong. I have notice that some toilet tanks I hold installed are loose that way. I don't close to it either but that's the path they're designed. Maybe you can put something between the tank and wall to prevent it from person moved around too much.
You installed it properly. If you're still worried, find some rubber spacers and place them between the tank and the bowl to back stabilize. But don't try to tighten the bolts any more; it will crack the bowl or the tank, later you'll have to start over again.
I basically put in a different toilet too
I'm not recommending this for you situation...
But I attached some wood on the wall astern the tank to stabilize it
Toilet manufacturer used to include rubber pieces that went between the container and bowl for better support and to prevent cracking the tank while tightening. They no longer do this. Try wedge a shim between the wall and tank.
Hi - Are near not a couple of holes in the top flipside of the cistern (tank) to screw it back to the wall. If so, smudge them, remove the cistern, drill the holes in the wall, insert plugs and refit the cistern to the vessel. Insert screws through the holes and tighten. Push a touch washer onto the screws up to that time you tighten them in. This will accomplishment as a 'buffer' between the screw and the cistern and reduce the possibility of cracking the cistern near the screws.
Alternatively - How much puncture is there trailing the cistern? Presumably this will be little/nil. Remove the lid from the cistern. Ease the cistern forward very slightly,( from your cross-examine this shouldn't be difficult). Squirt a bead of silicone sealant along the top/back edge and push the cistern final into it. Any excess silicone will squeeze out the top, wipe this off with care with toilet/kitchen roll. Make sure the cistern is smooth. This job is best done first article in the morning or end thing at hours of darkness, this will allow the silicone enough time to dry previously anyone needs to use the toilet. Leave the lid stale the cistern until the silicone is dry.
When i get a complaint from a customer more or less this this is what i do. If you look between your tank and bowl within should be a small gap. I tighten both sides of the bolts holding the container to the bowl equally until that gap is almost gone. Some tank have three bolts, in recent times go around a bit at a time. Then I tighten a bit more and push on the reservoir to see if it is still loose. If it is i tighten a bit more, and keep going until the container stops moving. Once it stops you stop to. Don't give it another partially turn just contained by case. You can crack the cistern or bowl. That said there is nought wrong with the path it is now as long as it is not to loose and not leak. Many plumbers tighten down those bolts just so it doesn't discharge and not all the road. Good luck!
Jamie T is correct!
More Questions and Answers...