Whirlpool Electric Cloths Dryer wont start?

I have a Whirlpool Electric cloths dryer that won't start. There is power to the component and the power checks fine inside the unit. I only just replaced the thermal fuse because the information with www.repairclinic stated it be most likely the problem. The dryer still doesn't work. I own checked all fuses next to tester and continuity checks good on respectively of them. I put the tester on the starter switch and power is going through it. I tested each lead going to the timer and each read good.
I don't know if the problem is next to the timer or not. I believe it is because when the timer is set for say 60 minutes I don't catch the sound of it clicking down the minutes. I hope that I described that angelic enough. If anyone can relief me out here I would appreciate it.


Answers:    There should be a wiring diagram on the support of the dryer and/or in the encyclopaedia if you have it...And remember that when checking continuity within stuff like switches/timers, you sometimes should disconnect them so you don't accidentally read thru another fragment of the circuit and get a false reading.

Use the electric wiring diagram, which will show the connections to the timer; (there are usually 4 or 5) and to the start switch and motor. That will help you trace where on earth the voltage needs to jump. Usually the timer controls both the motor and the heating component (like if there's a cool-down cycle) so make sure you're isolating the motor electrics.

Hope that helps!
coud b timer...when my dryer go bad the closing three times...1 burnt telecommunication...2 belt broke...3 door switch broke
Sounds like the timer.
It,s any the door switch or the start switch isn,t working.
More Questions and Answers...
  • Hardibacker comfort?
  • I want to connect plastic pipe (100mm) to clay pipes how do i do this?
  • Can i put a radio contained by a bathroom counter??
  • Should i catch a tama tackle beside no cymbals or a pearl utensils beside cymbals??
  • How do you install a compact wash mechanism?
  • 65 gph pump, will it work?
  • Is it risk-free, is it possible?