How do I lug chuck stale a Dewalt 14.4 cordless drill?

Im looking inside thte chuck and I see a screw with a star type bit. Anyone know the size/type bit to use to lift this screw out?

I have a Dewalt XRP model dw983. 14.4 cordlewss drill/driver


Answers:    Can't let somebody know you the size of the star. But I will tell you that the screw is more than possible reverse thread. Turn it to the right to loosen it! Then after you remove the screw use a fairly accurate size (ell) shaped allen wrench. Put the short end surrounded by the chuck and close the chuck around it (like it was a drill bit) Then thump on the long end of the allen wrench (hex wrench) beside a hammer to remove the chuck from the drill. Just did it to my milwaukee partly inch and it worked great. Oh ,soak that screw in wd overnight too! It will support breaking that bugger loose.
There should be a screw on the inside of the chuck with reverse threads. The chuck have to be wide initiate in demand to get it past its sell-by date.
More Questions and Answers...
  • When installing laminate tile how close do you fit the tile to the T molding?
  • How do you re thread a Handy Stitch?
  • Painting over pitch-black paneling in need sand?
  • How can I bring a marble table that have lost its shine, and have coffee cup "rings" on it, spinal column to its shiny, b
  • What can be used within place of a wall tile cutter foot tool?
  • Concrete explodes?
  • Has anyone ever returned laminate flooring to Home Depot?