For a non-handy party, how tricky is it to install different door knob on interior doors?
Answers: What you will be doing is replacing what is called a lock set or pathway set if it doesn't contain a lock. The holes drilled in the door to allow installation are pretty much standard if the door have been manufactured since the sixties, and should readily adopt the new lock/passage sets. The solely difference could be the shape of the piece at the end of the striker (latch) can be any square, round cornered or drive-in. Adjustments in the shape of the mortise (cut contained by the wood) can be made with a tack hammer and a wood chisle, a sharp 1/2" will do nicely, a blade knife will also aid. On the casing side one and the same is true, the shape of the mortise may need to be altered. Note: the drive-in does not own a faceplate but does have a plastic collar around the shaft to hold the striker tightly within the hole. Also note that a round cornered faceplate will fit into a square cornered hole but not vise versa and you will enjoy to remove the tiny corner to allow the square one to fit.
As far as purchasing replacements. Take one with you and also hold the diameter of the large hole(should be single hole of 2 1/8"), diameter of the small hole(an inch or less) and the distance of the center of the substantial hole from the edge of the door (standard is any 2 3/8" or 2 3/4"). From this a store service person should know how to tell you if yours are modern standard lock/passage sets. And both types of sets come next to readily understandable instructions beside drawings for installation.
You would use a lockset on an exterior door, a bathroom door and possibly on a bedroom door. All others, like stair doors and closet doors would obtain a passage set.
It is a piece of cake. You are merely going to unscrew 4 screws. If you can put a round peg within a round hole, you can figure it out.
Screwdriver and a few minutes.
Easy
Very confident. There are two screws on the inside pedal side and two screws on the perimeter of the door. Be patient and don't try to rush the post. Lining up the screws from the inside obverse of the door can take a few minutes, but if you relax and don't force it, it'll work.
BTW, adjectives door handles are standard so you don't want to worry just about size.
screw out knob on screw in its as simple as you know what
It depends. If you hold the old-fashioned mortise locks (the lock is a rectangular box set into a pocket surrounded by the edge of the door, have a traditional shaped keyhole) changing lately the knob is easy. They are held onto the spindle by a simple set screw. Just loosen the screw and verbs the knob counter-clockwise to remove it from the threaded spindle.
If you have the more modern cylindrical locks, it's a thing of removing 4 screws. Two hold the latch surrounded by the edge of the door, two hold the two halves hold the lock together contained by a 2 1/8 inch hole through the door. Also easy.
If you stingy that you want to replace mortise locks with modern ones, don't try it if you aren't valid handy. There are conversion kits available, but they involve path too much cutting and chiseling for an amateur.
I done a express Internet search and found a illustrate how to page on installing door knobs I have a feeling will be helpful for you.
More Questions and Answers...