Installing two or more electric baseboard heaters on impossible to tell apart circuit?
Is this ok?
Everything works but for some apology the thermostat is kinda warm.
Answers: You are fine the opening you wired it. The thermostat sees one and the same load any way. Line thermostats do acquire warm at 2250 watts.
1) Be sure the connectons are tight
2) The wattage (power) divided by splash voltage will yield your current draw (amps). Be sure your electrics can support the "total load" of both heaters.
3) If you are not tripping your circuit breaker that will be fine, but be sure the wiring at the nurture point is adequate for both lines it feed.
Hello,
In answer to your question concerning the baseboard heaters.
Regardless of how you have wired them.
All appliances enjoy a watt rating, I.E. a hair dryer would be more or less 1200 watts or 1.2 kilowatt.
Here is a simple formula
volts x amps = watts
let me explain this for you
If your house is supplied next to a service that runs on 120 volts and you have a circuit breaker rate at 20 amps ,that circuit will supply one or more appliances to a maximum wattage of 2400 watts.
Here is the math for the formula 120 volts x 20 amp circuit breaker = 2400 watts
Most houses have faithful circuits to supply high wattage appliances close to cookers, dryers etc.
It's imperative that you use the correct gauge of cable when you run any circuit.
Although it's possible to use a 12 gauge lead on a 50 amp circuit, you switch on the cooker and it works, the breaker does not trip off, but the lead becomes hot, it starts to soften, and next minute you hold free heat because your house is presently engulfed surrounded by flames.
Never mix two different wire gauge either.
If you enjoy installed the baseboard heaters using the correct gauge line everything will fine.
Some electrical things become warm when contained by use, dimmer switches for lights and thermostats are typical examples.
I hope this information shall be of benefit to you, and I have not stated the perceptible like ensure adjectives wires are tightened etc.
If you have any doubts, more or less the correct wire to use, consult a professional electrician or travel on line and find the answer from a reliable source.
Good luck
Paul M
britishb-- gave a exceedingly good answer. However, I disagree next to the thermostat getting warm. From the information you supplied, I gain that the thermostat is not a low voltage one. If that is the satchel, I would check to see what the max. rating it is, just to be sure you are not overloading it. Other than that, you did fine.
More Questions and Answers...