I necessitate to put within a socket for my cooker(for the sparker) this is going low plane losing cooker?
Answers: Three wrong answers so far. Be very cautious taking electrical advise from untrained race on yahoo. Especially those who lie almost being experts. You could burn your house down.
The receptacle you longing to install does not need a switch. It would be unusual to own a switch. Unplugging the unit would be the method for disconnecting power from it. That will comply next to the national electric code. State and local codes might over ride the national code but on this, I doubt it.
yes you should have a method of isolation and it should be a DP switch at large level above the appliance. Be measured in installing electrics within the home as new building regulations require that its properly certified and certificated.
It is indeed preferable to hold a DP (double pole) switch to isolate it, but not having one does not contravene the IEE Wiring regulations.
a fused spur is fine . you can after fuse it down to 3 amps as a sparker draws hardly any current...
by the bearing john himself . i am a fully qualified part p electrician. so i do know what i am chitchat aboout
No you dont; the double pole switch is just for convenience. Not have one does not go against BS7671 (British standards) of the electrics regulations as it can be isolated still by pulling the plug out of the wall and is fused down by the manufacturers plug-top.
Completed Apprenticeship
NVQ Level 3 surrounded by the I.E.E. wiring regulations 16th Edition
JIB Graded "Electrician"
Insatallation Electrician
More Questions and Answers...