Which saw is best can be used to trim the edges of a laminate floor thats layed already?
Answers: If you can fit a jigsaw where you involve to make the cut it would be slow, but honestly smooth. However if you need to cut remarkably close to the wall the only solution might be a sawzall. It's complex to make a straight smooth cut next to one of these though.
I am curious why you would need to trim the edges of a floor specifically already installed . If the edges are not even, just achieve a molding that will cover it up.
Circular is best, with a current blade to start with. Main problem is getting the saw close to the walls. If you own a steady hand, it can be cut next to a saws adjectives or reciprocating saw and a fine tooth blade. Put mask tape over the nouns to be cut to help prevent slit out and chipping of the new fringe. this also protects the floor for abrasion from the saw. Keep the work area verbs as the dust on top of the laminate floor is drastically slippery.
sounds like u hold a few short peices. u can simply add shoe moulding.
I hold a feeling I know why........conceivably the floor has expanded and its cause the laminate to pucker...been in that done that...........we have a special saw to cut lower than door casings that we use.....you can try to rent one except try a skill saw,kinda difficult but you can make it work..................
Fien make a triangle sander that has a small saw blade that will work unfaultable. the only problem is that the piece of equipment is about $225 but between the sander, the saw, the scaper, and the grout remover attachment it is one of the handiest tools I own.
first - parts should enjoy been properly trimmed past installation.
How did you get the 'too long' ones that obligation trimming in anyway?
Could use a trim that covers the serrated edge.
If trying to saw, take care you do NOT cut into the subfloor as this could seriously weaken the floor.
More Questions and Answers...