Gas hose stove pilot will flimsy. When I turn on the burner everyhing go out.?

Had a flood in the subterranean vault - did not reach the burner lately covered the air intake. Now I've tried to flimsy it several times. Pilot wil light and stay on. As soon as I try to turn on the burner everything go out. Have to wait five minutes in the past I can get the pilot lit again.


Answers:    Insure that the tip of the pilot thermocoupler (copper pilot line) is contained by the flame -- and that the pilot flame isn"t getting blown out when you turn the gas on. Clean the pilot tip assy. with a fine rope --- adjust the copper thermocoupler tip so that the pilot fire hits the tip part give or take a few a 1/4 inch approx.
This allows the main spout gas to come on ,and stay on.
Are you sure flood water did not procure inside the burner plate assy. ? Check again on this.
There might be air surrounded by the lines so the gas is not getting to the burner, let the gas dissipate for awhile and try lighting it again and after it lights hold it for a few minutes to return with the gas going. My gas water stove goes out sometimes and I enjoy to hold down the igniter for a minute or two before turning on the gas
More Questions and Answers...
  • Can i nurture clean panel from most important lugs on 200amp panel to prevalent braker on foreign panel?
  • How do I repair overhead Lights that have relays switches?
  • How do i fix a maytag washer if it does not turn on?
  • What is better textile for a shower pen, Cultured Marble, Cultured Onyx or Cultured Granite.?
  • Pressure on combi boiler leeps falling below nought departing me near no heat or hot hose down?
  • How to remove spray foam rotten my hand.acetone,alcohol, and soap do not work.?
  • Low Water Pressure Inside Home. Outside Water Pressure is Fine. Solution?