Cold tap does not shut stale on wash tool if hoses are switched and hot run through cold, cold closes?

If the valves are switch final after running hot through clold will close for a while. It seems to be a cleaning problem I tried running vinigar through the procession do not know hot this work yet. own not switched back the cold hose all the same


Answers:    Your washer has an internal switching stopcock. Sounds like it's out of commission properly. It's a service issue. Most likely the spout is stuck open and can no longer switch. I enjoy had to replace these. They are a single component on the back of the washer. It's the cut where the hoses connect to the washer. This is a one piece element with electrical connections that can be efficiently replaced. It's really not hard to replace.
You must replace the dual wet valve, what hose down comes in depend on what your sea temp switch is set on! You need the cold wet wkg properly to complete a cycle. Because rinse cycle uses different settings than the wash cycle. If you can't locate stopcock locally go to www.marcone.com and you can messages order within.
More Questions and Answers...
  • Can a pocket door be removed or used to?
  • Okay. A key storm comes through and the power go out. What does it mean to procure the power hindmost?
  • Who would be best to diagnose why one of my rooms get much colder than any of the others?
  • Problem beside my bathroom mirror?
  • Can anyone explain why it is that my porthole screen's hang on to getting holes contained by them?
  • Does anyone know how to fix my dryer?
  • We are have a roof put on and it is raining...it is locked for the roof to shingle surrounded by the precipitation?