Hot Water Heater Leaking?
Answers: I don't see any indication as to type of heater section, elec., or gas, but the leak problem doesn't really relate to that anyway. The generous amount of rust and corrosion on the nipples connecting the unit to your sea system, however, does relate. If there's that much activity going on near and someone else has already replaced piping, etc, surrounded by that area, likelihood are the unit is rather old and most plausible getting a fair amount of lime, calcium sediment built up within the base of the reservoir. This is the caustic stuff that cause the corrosion on the piping and also eats the tank walls till a leak occur. It may be time to simply cut your losses and replace the entire tank. As to draining, you involve to stop the water supply to the container, either by shutting rotten a valve that should be located somewhere essential the tank, on the cold wet side, or shutting down the supply to the whole house. Once that's practised, you can open the drain tap and hook up your hose and drain into a sump area or a short time ago a drain hole in the floor if you hold one. If you have to push it up and out of the crypt, then you can pressurize the container, by installing a special nipple on the relief spout and using an air reservoir. If it's an electric model, of course, shut stale the power before draining, if it's gas, turn bad the gas before disconnecting.
Its best to agree to the water run threw the drain hose first to blow out sediment but your alright turn the dampen off at the street attain all the sea out TURN OFF BREAKER and go put a bet on with compresion fittings exotic supply lines & cut off spigot if possible .dont foget to use plumbers video yes you have to agree to air contained by while draining it ill filch forever otherwize fill it adjectives the way & run marine to all your sinks previously turning breaker on good luck
More Questions and Answers...