Where can I find info on the web about building code concerning hand railings in stair wells?

I live in Schenectady NY and can't seem to locate anything on the Internet about this subject.

Answers:
Try www.ecodes.biz It's the international codes website. I personally would call the city development office/building codes and inspections department and ask an inspector just in case there are any amendments to the existing codes.

Other answers:
Try this website below. I'm the Building Committee chair for my Church and when we had to make our church more handicap accessible, we use the dimensions provided below. You'll find most states adopted this standard. Good luck.
Try this website below. I'm the Building Committee chair for my Church and when we had to make our church more handicap accessible, we use the dimensions provided below. You'll find most states adopted this standard. Good luck.
Most localities will have adopted a generally accepted code... but some are stricter.... it's those areas you have to look out for... You really should check with your local authority. You can always 'overbuild'... or make things to a higher standard of safety... but you can get in real trouble, if you do not meet the local codes.

You may need a permit, and inspection too... find out when you contact the city office. Most stairwell railings, are attached to the walls.... about 30" up from the floor. You will need at least one side railed from the top of the steps to the bottom, if the steps are 3ft wide, or smaller... wider than 3ft, it is normal to see a requirement of railing on BOTH sides of the stairs. If this is an exterior stair well, then you may need to install metal railings.

Good Luck!
That would all depend on your township I would look up the number for the township codes inspector and ask them
Is there someone in Utah that repairs caning?
  • I had a fire in my home, and now we are having problems with the restoration company. any ideas?
  • How good are Goodman air conditioners?
  • Slippery Concrete?
  • Liquid detergent spilled on dryer and makes noise when it runs, is this fixable?? I'm scared to let it run.
  • can you sell a house that had all the plumbing installed by someone that was not a liscensed plumber?
  • how to change a 220 volt motor to 110 on a radial armsaw (sears)?
  • how to start a murry D97-31-4 riding lawn mower?
  • What is the best home heat source?