To wirer a elec swich to a flimsy can you hot cable from the box?
Answers: You stipulation a hot wire to the switch. And a switched hot flex from the switch to the light. You also obligation a neutral on the restrained.
uh...sounds like if you don't know how to do it (much smaller amount describe it better, sorry), you should call a LICENSED electrician. Wiring 'hot' vehicle leaving the electricity 'on' while you do the work...even a pro will hold the electricity, since if he/she works 'hot' and there's an accident, etc., near are insurance and liability issues involved. Do yourself a favor: make the phone to a pro
Well hopefully your not the one doing this. But you can wire from the panel to the switch, or from the panel to the standard lamp. either means of access. Good Luck
You can run the hot wire to the lantern fixture then to the switch or to the switch first and consequently the light fixture. Either instrument will complete an electrical circuit. The safest routing will be to run the hot wire to the switch first so you can disconnect power when you own to replace a bulb. In your case, hire an electrician.
It depends on your configuration. If within is only one switch, later power can be wired from the fuse panel to the switch and then to the table lamp, that’s the normal configuration. If explicitly inconvenient, then power can be wired from the fuse panel to the street light, then to the switch. In any case, brand sure you comply with the National Electrical Code or hire a licensed electrician.
More Questions and Answers...