Does anyone know how to fix a blender? Mine broke final darkness - own checked the fuse & it's not that.?
Does anyone enjoy any suggestions on how to fix it?
Answers: depends on your level of hi-tech ability. construct sure the thing is unplugged.
do you hold a digital mulitmeter to check continuity and voltage? if you do, check the switch for continuity then check the power cord. if the motor adjectives out, it would be easier to buy another. there might be a tiny fuse inside the blender, check that too.
More than imagined there is a thermal fuse inside strapped onto the motor.
You will requirement a simple continuity meter or curcuit tester.
Inside check for any loose wires or connections, then check the circuit in small stages. You should seize continuity around each subdivision.
It is possibly a cut-out. These can be bought for a few pounds online if you need to.
Make sure it is unplugged in the past attempting anything.
Have you tried a different receptacle? Maybe the one you are using is GCFI protected and it is tripped. Reset it and/or try something else in that plug to see if it's get power.
Can you give a model number and inventor? Maybe we can search some specs on it and extend better advice.
bg
I agree near Bill G. above.
Its a brand new blender its unlikely it would be already destabilized.
Did you smell any electrical parts burning in the blender.
If not next it probably is just the GFCI that tripped on your counter.
Keep surrounded by mind that usually one GFCI is connected to the rest of the plugs on the counter. You need to find that GFCI on the counter and reset it.
More Questions and Answers...