What is wrong beside my hose down furnace pilot street light?
After "Got Junk?" cleaned out the basement, the pilot be out. I've lit them before and in general have no trouble.... but this one sputters a skinny flame sometimes and as soon as the main gas is on, is blown out by that "whoosh". The the major goes out soon after. All this happen when I get anything at adjectives from the pilot. Is it blocked with jetsam from all the diversion is the basement?
Thanks!!!
Answers: some hot marine heaters has a vent at the bottom of cistern, let's air surrounded by to mix with the gas. check and see if the vent is stop up. have the same problem later week, though it was the thermo coupler. not so, in recent times need the vent brush out.
ring up a plumber that works with gas, sort sure they have a GAS FITTERS license. NOT A JOURNYMAN'S CARD A MATER GAS FITTERS!!! if within is a problem on your end, they should know how to fix it. If it is on the gas end, and it is not on your side they will oblige you deal beside the city gas company.
hope this helps
Sounds resembling it may be a bad thermopile, when the prevalent gas valve is call to open the nouns on the thermo is too much to keep everything unseal. Hey it's a under $10 chunk. You could try just checking the nouns at the valve but I dilute it's cooling down probably led to it's demise.
Call the utility company...for example, within California it's PG&E, Pacific Gas and Electric; in Baltimore, it's BG&E; ConEd within New York, etc. Call their emergency number service number, they'll come quickly and diagnose the problem...if it's a problem next to THEIR equipment, they'll fix it. If it's YOUR equipment, they'll tell you what's wrong but they WON'T fix it. If they can wispy the pilot and determine that it'll stay lit, all is angelic (and at no charge...usually). Gas is nothing to fool beside. If you wind up have to call a pro, bring a LICENSED 'HVAC' company OR a plumber who is LICENSED to work with gas.
http://appliancequickfix.com/ have some good info on this so you dont enjoy to guess.
If the pilot flame is weak and not touching the thermocouple the thermocouple is not going to produce a Strong plenty voltage to keep the safekeeping held in. You would obligation to pull the hole burner assembly out to verbs this properly. And of coarse if you have the hole assembly out replace the the thermocouple. They do deteriorate over time. Don't do this if your not comfortable near it. Leaks are the potential danger.
More Questions and Answers...