on my lennox heat pump, the lowest of the three brackets that hold the blower motor into the housing broke off right where it mounts into the motor. it looks like they are welded in. Cozyparts.com has some replacement brackets and I was wondering how hard it would be to use one of those.
Answers:
This is a special motor made for Lennox, and it will be expensive to replace. Another way to do it is to get the numbers off of the motor nameplate. You will need horsepower, voltage, RPM, length of motor without shaft, diameter of motor, and size of the shaft. Take this information to a electric motor dealer. They should be able to get a motor to meet the specifications. next you will need a belly band mounting kit. This is a band that will go around the motor, and will have 3 or 4 mounts on the band to bolt to the blower housing. SHould be able to out it all together and be redy to go. Hope this helps! Good luck!
Other answers:
Which of the following piping systems are normally under pressure-vent, suppply, or drain?
I have a problem with a three-prong outside electrical outlet. The tripper will not reset. I need help.?
The sprinkler heads spray water, but do not spin,,why and how to fix? Thanks?
How much will it be to fit a new timber door?
the bottom portion of the wall in my room has started to chip. its weird. anyone know why this could be?
What the best way to remove broken shards of glass from a rusty double hung window.?
Why does my garden hose spigot spray water when I shut it off?
how do I replace my old ugly ceiling with a new one?Unknown "goo" contained by underground store, lend a hand!?