Pliot night light on but will not fire up to steam dampen and radiators?

i had a bleed in one of the radiator pipes so turned of marine supply when pipe fixed and water supply hindmost on the pilot light
come on but will not fire up to heat river or radiators


Answers:    If the heating system have been drained to fix the outflow,then it could be full of nouns.Airlocks will stop the hot water surrounded by the boiler from circulating and the thermostat will prevent the boiler from firing.Bleed all the radiators next with the time controller set for on,shut adjectives the rads down bar one to force the heavens out.Once this rad is hot,repeat with adjectives the other radiators.Bleed the air out the pump by turning the considerable screw in the middle anti clockwise.
If the boiler is a combi then the sea leak have caused the boiler to lockout due to low pressure,it could be a casing of refilling the system via the wadding loop under the boiler to 1.5 slab.
Theres probably a reset button on the underneath of your boiler - have a look, if that fail call a plumber.
More Questions and Answers...
  • HELP! Spiders !!How To Seal Up Basement Ceiling? Pic included?
  • My kenmore 417.29052991 washer stopped agitating and spinning. what is the problem?
  • Is it easier to run a dampen procession or a 220 electrical procession?
  • Can copper plumbing tubing go and get satisfactory condensation to trickle onto the ceiling from the 2nd floor?
  • GFCI Outlet quiz?
  • What could do a Frigidaire pro series refrigerator rime architect with the sole purpose construct crushed rime?
  • Storm door (8 ft x 3 ft)?