When trialling the elements on a electric hot hose down oven should nearby be a short or no short?
Answers: Do you miserable a WATER HEATER ?
because if you already have hot sea why heat it !
if the river intake is cold ,it is a WATER HEATER,one that heats up cold wet into hot.
The elements SHOULD pass current - when they don't later they need replacement.
Sounds resembling the thmerostatic control is failing to turn off the current when the wet arrives at temp?
Check the mfg date ( on a plate) - if it's like 10 yr infirm I'd just replace the entire reservoir rather than try to buy a control.
When you assessment a heating constituent you should have a "short", a complete circuit. What you involve to check is how many ohms of resistance should it be. If is supposed to be 15K ohms (for example) and in a minute it is reading 9K ohms this could explain the scalding water and the circuit tripping out. It's scarce that an element would do down surrounded by ohms but with sediment from wet forming on them it is possible.
Check the ohms on each item to see if they are at the correct value.
when you assessment the heating elements first turn sour the breaker.
then remove one line from the element.in a minute you test for continuity. if the elements overt it needs replaced. occasionally an thing that shows a short is bad also, but an accessible reading is always desperate.
the other element is probably at the closing of its lifespan, i would recommend replacing both.
if you turn off the dampen supply, open a faucet to tolerate off the pressure, you do not necessitate to drain the tank. of late be very sudden and have a bucket equipped. some water will bring back out and its HOT.
A heating component is a resistor. When electricity passes thru it, it resists the electricty and it give off roast. Your continuity checker should show that there is a "short." This sounds to me close to the probelm is not in the elements but within the controls. Your thermostat should be set low enough to not hold scalding water. If this marine heater is antiquated, I'd put in a investigational water kiln. You could spend way more on parts than a unusual heater costs. And the newer heaters are much more liveliness efficient.
More Questions and Answers...