How do I fix leaks in a metal dunking booth? Is there a product that will fix the leaks fast? Please help!!?
Answers:
Welding is the fastest, so if you don't have time to weld it then you don't have time to use J.B. Weld
Other answers:
J B weld works great and underwater. Hardens like metal. It's a 2 part epoxy. Found in most home stores. Home depot, lowes , true value.
J B weld works great and underwater. Hardens like metal. It's a 2 part epoxy. Found in most home stores. Home depot, lowes , true value.
sand it a little and use some jb weld you can buy it at autozone walmart just about anywhere its a epoxy 2 parts mix it and put it on the holes
They have a gas tank/radiator repair product at auto zone.I've even seen it at the dollar store.
at the auto stores and some hardware stores they sell tank plugs wherever you have a hole you just drill it a bit and screw these in.all they are is a self threading screw with a rubber and metal washer attached.i have used them and they work ,especially in a pinch and with no time to do anything else.
i see Wendy mentioned something that sounded like seal-all comes in small tube on anything larger that pinhole i use fiberglass or mesh cloth wire brush off any loose scale coat of seal all apply cloth nother coat let dry repeat if at very bottom anything larger than inch or so is best to use rigid reinforcing or as some have said weld er up but then again is probably rust holes and they just get bigger w welding
Unless you have a Mig welder, buy some JB Weld or Epoxy Putty, and follow directions EXACTLY. That should do it.