I entail instructions on how to alter a belt on a bolen riding lawnmower?
Answers: Which belt is it? The drive belt for the transmission or the deck belt?
Well, pretty much any way the deck will call for to be removed to gain acess to both. the deck will have guards that necessitate to be removed to put the belt on the pulleys - if the old one is still on- produce a drawing of how it looks before removing it.
To remove the deck :
Depends on the brand tractor, but in general a few pins hold it on the tractor - again make proceedings of where they adjectives go formerly removal. The deck belt is held on the crank pulley by two or three retaining bolts ( helps hang on to the belt from comming off), these need to be unscrewed to bring the belt off.
I usually elevate the front of the tractor with a jack underneath the front axle to slide the deck out easliy, just breed sure the rear wheel are chocked to prevent rolling.
The drive belt underneath will be a bit trickier , sometimes theres guide plates in the course that need removing. Again spawn a drawing of the configuration before removal. There will be belt retaining pins on the trans drive pulley. After adjectives the pins and retainers are removed , push on the clutch, itll release tension on the belt , so itll come bad. There might be two drive belts - both attached to a center pulley . Your local autoparts store carry replacement belts - only just mention heavier duty for a lawntractor, plus if you still have the belt, they can game up the numbers.
If you have any question let me know
Most of the newer mowers enjoy a diagram on the deck for deck belt replacement and a diagram for the ground motion belt somewhere on the tractor. Look under the hood or underneath the foot rests.
More Questions and Answers...