Central nouns conditioner does not cool second floor?
Answers: ok
it's not powerful enough. you probably want to get a second one for the upstairs and use fan to push the cool air throughout the house. most a/c unit will say how lots sq feet they are recommend for.
Either your AC component is too small or the duct work is too small or routed incorrectly most likely.
Best bet is to catch a repairman out to assess the situation.
You may need to any replace the unit, replace or re-route the ducts, or cheapest process may be to just achieve a window part or two and use them on the second floor.
Keep in mind that according to the ruling of thermodynamics, hot air rises and cold nouns drops. Are there supply vent on the second floor? If so, is their a return air grille as in good health? If so does the return air grill own a filter in it? If yes, is it a dirty or clogged filter? If yes, can you access it to conversion it with a spanking new one? If yes, has at hand been a metamorphose in the airflow heat? If yes, is it cooler or no change? If in that is no change, is the thermostat mounted on a wall downstairs or upstairs? Are in attendance more than one zones or thermostats contained by the house? Have you checked the fuze box to see if their is an addition a/c element that is tripped or not powered on? The more info you can provide, the easier it will be to troubleshoot. For instance, do you enjoy a low refirgerant charge? Is the second floor well insulated? Do you hold a dropped ceiling that hot air is pouring down from? Do you own an old thermostat? Or you can telephone call for an HVAC service tech.
There could be several reasons. Sometimes, within older homes within was no ducts run to the second floor. For more info go to www.hvac-for-beginners.com
Best to hold the ductwork checked for leaks first and I don`t know have a more powerful blower or booster fan installed in the ducts to support push the air up to the second height....cold air requirements to sink by nature. Same problem within my house---attic heat make the second story warmer and take a lot to cool it. Try tallying more insulation in the attic as well---I put 20 inches of blown-in into mine and it help a lot. Having a powered attic vent will drop off the attic heat as ably and make it easier to cool the 2nd story. You may hold to go beside a zoned a/c system if it's affordable to get the best results or affix a window component.
first, check the obvious... a dirty filter. it should be changed at smallest twice each heat and cooling seasons if you're using a 1" filter. 4 times a year at minimum.., but you can never enjoy a too clean filter. and use a power filter (pleated) not the 3 for $1 crap. you might as well video a piece of paper towel up. you obtain what you pay for.
2nd... as previously stated, hot nouns rises. chech out your thermostat and try changing the devotee setting from "auto" to "on" if you haven't already. in the "on" postiton the blower will run non-stop and you'll find a more consistent temp from top to bottom because the fan is constantly mixing the heavens. make sure you go inside doors open for better nouns flow. if you're getting good airflow from the upstairs vent but the air isn't coming out as cool as it is downstairs, there's not much you can do just about it now (it's an insulation thing) but this will give a hand. using a duct sealant you can pick up from any hardware store to fill contained by any gaps that you own access to will also help.
3rd... is this a unusual problem? if it's only getting worse and the drop surrounded by efficiency is spreading to the rest of the house it indicates a freon problem and should be checked on by a professional.
4th... characteristic windows and extra insulation surrounded by the attic will be a tremendous help. especially within older homes. attic fan(s) as all right. if the house is drafty and the inuslation is poor that only increases the warmth load.
second... if your furnace is pretty old, 15 years or more, it's time to upgrade. bring back it replaced and go beside a variable speed motor. don't verbs this with a motor that have different speeds for heating and cooling because that's a given. a furnace next to a variable motor will in reality measure the amount of airflow (cfm) and increase the rpm's of the motor if the airflow drops. for example if you close the vent in the subterranean vault and main floors to catch more airflow to the top floor the variable motor system will authorize this and ramp up the rpm's. it won't work miracles but will do a lot to overcome poorly designed duct work. surrounded by a traditional old college system you'll just freeze the system up because the atmosphere flow is too slow.
without seeing the setup it's tricky to say. I tried to plan my answers from most likely and lowest expensive and moved on from there. hang on to in mind that most reputable companies will dispatch out a consultant to give free quotes on anything you want. tolerate me know if you have any question.
More Questions and Answers...