I enjoy an ariens grassland tractor. It is of the emperor models. It is verbs start, but wont start. What do i do?
Answers: Remove the spark plug, reattach the plug wire to it, after lay it down on the head or somewhere where on earth the metal part touches the cranium or elsewhere on the engine, and pull the starter cord. You should see a spark at the tip of the plug.
If you don't, later the ignition system may need repair.
If there's spark, afterwards try dumping a small amount of gasoline (~1/2 teaspoon) into the carburetor throat and then verbs the starter cord a few times, if it fires up for a second and then dies, there's no gasoline getting into the combustion chamber from the carb.
Beyond that adjectives that an engine needs to run is nouns and compression, which I presume it has (tho' you didn't right to be heard if you've ever seen the engine run, and but for, all bets are bad!)
If you don't have a compression tester, a hasty and very crude try-out for compression is to pull the starter cord slowly - the engine should hold enough compression to pretty much stop the rotation. If not, consequently there may be a stuck spout or some other problem (head gasket, cracked piston, etc).
Last, if the gasoline in the reservoir is extremely old, ancient gasoline is notorious for cause hard starting - it "sours" by means of access of an oxidation process and loss of some volatile components. Try some fresh gasoline.
did you check to see if it had spark if it have spark that leaves carbaration take the undamaged carb a part if you don't hold a repair manual achieve one from the library use carb cleaner don't forget to clean the jet
RayB did a very apposite job surrounded by his explanation! But if it does turn out to be the carb I suggest taking it in to a shop and hold a professional rebuild the carb. This should fit into your budget and carry you mowing ASAP!
(even professional landscapers pay shops to say their equipment)
More Questions and Answers...