What cause the pressure difference surrounded by sprinkler spout dampen output between the booklet and timer triggered ?
Answers: Well, this is an interesting problem since most hydraulic problems will occur while any manually or electronically turning on a valve. Valves indeed do own pressure losses, and as an example a Rainbird 100-DVF with 10 gallons per minute flowing through it will lose 3.8 psi. This loss however occur when the valve is manually operate as well since the marine takes one and the same path through indistinguishable valve. If your spigot has a flow control, this too will alter the flow when manually operating the valve as okay. Therefore, I would target in on the differences between almanac and electronic operation, which centers on the electrical and valve’s solenoid.
I’m wondering if this happens beside only one spigot, or with adjectives? First of all, let’s label sure that you aren’t having another zone come on at duplicate time whenever the controller is operating! Now, if you have another similar stopcock that does work next to the one contained by question, can you swap their solenoids along near their wiring? I’d close to to know if the valve works on another zone, solenoid, and chain set. It is probably possible that there also could be a small bit of dirt within the solenoid’s control path quantity of the valve specifically causing problems. You may want to remove the solenoid and try to verbs that area out, as in good health as check the solenoid itself for a torn filter. With it removed, it should actuate easily when the controller activate it. It is always astute to check the solenoids wiring, more than ever where it connects to the control cable. Make sure these connections are virtuous and dry. If you have a volt meter, near the zone running you should get going on for 24 volts ac. Too much of a voltage drop, which happens beside smaller control cable or long runs, can cause problems… especially near poor connections.
Below is a diagram of a Rainbird valve that may be of use, or citation.
If the pressure in any one zone is different than the other zone it could be one of two reasons; any the pressure is high (usually due to one or more sprinkler head not poping up), or its low (usually due to a leak within the pipes). Something that could cause low pressure contained by all the zone are an obstruction surrounded by the water string above the valves (unlikely), or a hole surrounded by the line above the spigot (the water would be wadding the valve box and cause damage to the prairie wherever it is located), or leak in adjectives the lines (again would be easy to identify from the excess wet in the ground at the source of the leak).
Lastly the spigot itself could potentially be faulty. The solenoid inside the spigot holds the valve accessible when electricity is applied across it. If the wires to it are damaged; if the solenoid is discouraging; or if the valve have any rust or dirt inside that could cause a lower than commonplace amount of water flow.
More Questions and Answers...